Braun Silk epil EverSoft 2390 Manual De Instrucciones página 13

The fine hairs which regrow might
not manage to get through to the
skin surface. In order to prevent
in-growing hairs, we recommend
the regular use of massage sponges
(e.g. after showering) or exfoliation
peelings. By a gentle scrubbing
action, the upper skin layer is
removed and fine hairs can get
through to the skin surface.
How to epilate
• Your skin must be dry and free
from grease or cream.
• Before starting, thoroughly clean
the epilator head
• Put on the epilator head and make
sure that the EverSoft attachment
is in place.
1
• Plug the cord connector
the socket
5
former plug
7
outlet.
1. To turn on the appliance, slide
switch up to setting «2»
4
(«2» = normal epilation,
«1» = gentle epilation).
2. Rub your skin to lift short hairs.
In order to make best use of the
EverSoft attachment, hold the
appliance at right angles (90°)
against your skin and guide it
against the hair growth and in
the direction of the switch. When
using the EverSoft attachment,
make sure that both wheels are
always kept in contact with the
skin. Do not press too hard.
.
2
into
6
and plug the trans-
into an electrical
3. Leg epilation
Epilate your legs from bottom
upwards. When epilating behind
the knee, keep the leg stretched
out straight.
4. Underarm and bikini line epilation
User tests monitored by dermatol-
ogists have shown that you may
epilate under the arm and at the
bikini line as well. Be aware that
these areas are particularly
sensitive to pain. However, the
pain sensation will diminish with
repeated usage.
For this specific application, we
would like to give the following
advice: Before epilating,
thoroughly clean the respective
area to remove residue (like deo-
dorant). Then dry with a towel,
carefully using a dabbing action.
When epilating underarm, keep
your arm raised up and guide the
appliance in different directions.
Cleaning the epilator head
5. After epilating, unplug the
appliance and clean the epilator
head: First take off the EverSoft
attachment
1
rolls.
6. Thoroughly clean the tweezer
element with the cleaning brush
and also with cleaning fluid
(e.g. alcohol). While cleaning,
you can turn the tweezer element
manually. To remove the epilator
head, press the release buttons
on the left and right and pull it off.
and brush out the
3
13