Battery Removal - Remington Smart Edge XF8500 Manual Del Usuario

ENGLISH
, TO REPLACE THE FOIL
• Remove the foil assembly by pressing the foil assembly release buttons on
both sides of the head and lifting the assembly upwards to remove from
the hair pocket.
• Insert the new foil assembly on the hair pocket, press down and click into
place.
, REPLACING THE CUTTERS
• Grasp the cutter between your thumb and forefinger and pull firmly
upwards.
• Snap the new cutter into the oscillator tip.
, Note: DO NOT press on the cutter ends as this may cause damage.
• Foils head replacement model: SPF-XF87 (XF8700) & SPF-XF85 (XF8500)
, TROUBLESHOOTING
• If your shaver battery is completely empty or the shaver has not been used
for an extended period of time place the shaver on charge for about 2 hours,
or if needed immediately, a 5 minute quick charge will allow for 3 minutes of
shaving.

BATTERY REMOVAL

• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing
the battery.
• Using a small screwdriver, pry off the (2) side panels.
• Using a Philips screwdriver remove the (4) screws from the front of the
shaver and remove the front housing.
• Using a Philips screwdriver remove (8) screws from the front of the shaver.
• Remove and open the core from the shaver to expose the batteries.
• Cut the wire connecting the batteries to the circuit board and remove the
batteries.
• The battery is to be disposed of safely.
H ENVIRONMENTAL PROTECTION
To avoid environmental and health problems due to hazardous
substances in electrical and electronic goods, appliances marked with this
symbol must not be disposed of with unsorted municipal waste, but
recovered, reused or recycled.
6