Operation With Display - Vortice VORT INVISIBLE MINI Manual De Instrucciones

ENGLISH
Operation with remote control display
The product VORT INVISIBLE MINI can be controlled through a remote display LCD HMI supplied with the
product.
User interface
The following operations can be performed through the user interface:
• Temperature control;
• Air speed adjustment;
• Weekly air speed programming ;
• Alarms management.
• Setting the relative humidity (TOP models)
The below table shows functions related to each key on the interface.
I
Function 1 recall key.
II Function 2 recall key.
X
Key to exit from the displayed page.
Key to: increase speed / move to the upper
▲
row or value.
Key to: decrease speed / move to the lower
▼
row or value.

Confirmation (OK).
Key and display backlighting remains active for about two minutes after the last key is pressed.
When backlighting is off, you can switch it back on again without activating any function by pressing any key.
This means that, to turn the display back on, press any key and then press the desired key again.
"HOME" page
Upon start-up, the display shows the manufacturer's logo for about 10 seconds, then it goes to the "HOME"
page. This page allows you to view various data useful for controlling equipment.
The data and information that the page can display are indicated in the figure and table below.
1
• Normally blank display area.
• "Bypass", in case its function is active;
2
• "No-Frost", in case its function is active.
• Equipment operating status display area:
Speed: "MIN", "MAX".
• In the event of alarm:
- with the unit lock: "Alarm!" Message alternating with
3
"Block!";
- without the unit lock: "Alarm!" Message.
See "Alarms" in the "Operation and Use" section.
• "Holiday", in case its function is active.
• "Ext' Value of the outside air temperature (Example: Ext
4
+5°C) after pushing the button [II].
44
I
Display
II
X
The below picture is showing the
different display areas
1
3
4
6 6 6
2
5
7