Kit Preparation; Kit Assembly - Metra 95-7353B Instrucciones De Instalación

Kit Preparation

1. Mount the a/c vents, storage pocket,
hazard switch, and passenger air
bag indicator into the 7353 radio
trim panel. (Figure A)
2. Mount the start/stop switch or blank
plate depending on your application
into the 7353 radio trim panel.
(Figure A)
Note: If no switch is present
there are (2) #8 X 3/8" Phillips
truss head screws supplied to
mount the blank plate.
3. Install the (8) factory panel clips
onto the 7353 radio trim panel.
Continue to kit assembly
95-7353B
Double DIN head unit provisions
1. Mount the DDIN radio to the radio
brackets using the screws supplied
with the radio. (Figure A)
2. Mount the radio/bracket assembly
into the dash.
3. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
4. Reassemble dash in reverse order
of disassembly.
3

Kit Assembly

(Figure A)