Resumen de contenidos para cascade corporation 60A
Página 1
SER MANUAL Fork Positioners Original Instructions Number 6536947 EN cascade corporation Cascade is a Registered Trademark of Cascade Corporation...
ONTENTS Introduction This manual provides instructions for installing, operating and maintaining a Cascade 60A Fork Positioner. Follow Operation the suggested procedures for best results. If you have any questions or need more information, contact your nearest Safety Rules Cascade Service Department (see back cover).
NTRODUCTION This user manual is for the Cascade 60A Fork Positioner. Weighted Emission Sound Pressure Level - Weighted Contents include an Operator's Guide, Installation emission sound pressure level (LA) does not exceed 70 Instructions and Periodic Maintenance. dB(A). Measured Value of Whole Body Vibration - Measured NOTE: All specifications are shown in Metric units.
PERATION Safety Rules – Industrial Lift Trucks No riders No reaching through mast No standing under load FP1720.eps With Load Tilt Raise 8 cm No Load RAMPS Traveling Motor off, park, lower load empty No parking on ramp No turning on ramp Watch clearances FP1721.eps TRAFFIC...
PERATION Safety Rules – Handling Loads Limit sideshifting with raised load Top of load should not extend above backrest CAUTION: Do not put side loads on forks LOAD Center load WEIGHT prior to traveling Limit truck movement FP1722.eps with raised load Load weight must not exceed combined truck/attachment capacity (see truck nameplate).
AFE OPERATION AND MAINTENANCE Industrial Trucks and Attachments WARNING: When operating and maintaining industrial trucks equipped with attachments, you should pay particular attention to the following information. You should be familiar with this information for truck and attachment operation. Ask your employer for complete operation information.
15 LPM 26 LPM 26 LPM ➀ Cascade 60A Fork Positioners are compatible with SAE 10W petroleum base hydraulic fluid meeting Mil. Spec. MIL-0-5606 or MIL-0-2104B. Use of synthetic or aqueous base hydraulic fluid is not recommended. If fire resistant hydraulic fluid is required, special seals must be used.
NSTALLATION Hydraulic Supply 60A Fork Positioners can be operated with any of the hydraulic supply arrangements shown below. Refer to Cascade Hose & Cable Reel Selection Guide, Part No. 212199, to select the correct hose reel for the mast and truck.
NSTALLATION Attachment Installation Attach overhead hoist Remove lower hook pins, lower 2000 lb hooks, reinstall pins. 900 kg FP1696.eps FP1695.eps Mount on truck carriage ITA Class IV – 18-20 mm Center Notch ITA Class IV – 12-13 mm FP1697.eps Truck Upper Carriage GA0035.eps...
Página 10
NSTALLATION Flush hydraulic supply hoses A Install hoses B Operate auxiliary valves (both directions) C Remove hoses GA0435.eps Install hoses Forks In Sideshift Right Forks Out Sideshift Left FP1700.eps Auxiliary Valve Functions A Sideshift Left B Sideshift Right C Forks Out D Forks In Tilt forward Hoist down...
ERIODIC MAINTENANCE Daily IMPORTANT: After completing any service Check items shown each day. Report problems to your procedure, always test each function through 5 supervisor. Refer to service manual for troubleshooting, complete cycles. First test the attachment empty, maintenance and repair procedures. then test with a load to make sure the attachment operates correctly before returning it to the job.