Charger Mounting - GreenWorks 29842 Manual Del Propietário

BATTERY CHARGER
CHECKING THE CHARGE
If the battery pack does not charge properly:
• Check the current at the power outlet with another tool. Make sure that the outlet is not turned off.
• Check that the charger contacts have not been shorted by debris or foreign material.
• If the surrounding air temperature is not normal room temperature, move the charger and
battery pack to a location where the temperature is between 45 ˚F and 104˚F .
WARNING
If the battery is inserted into the charger when warm or hot, the CHARGING LED indicator light
on the charger may switch on and illuminate ORANGE. If this occurs allow the battery to cool
outside of the charger from approximately 30 minutes.

CHARGER MOUNTING

1. This charger can be installed hanging on a wall using two screws (not supplied)
2. Locate the placement for the charger to be wall mounted.
3. If fastening to wood studs use 2 wood screws.
4. Drill two holes 2 3/8" (6 cm) on center ensuring they are level.
5. If fastening to drywall use wall anchors and screws to secure the charger to the wall.
6.This power unit is intended to be correctly orientated in a vertical or floor mount position.
NOTE: If the battery and charger is stored for a long period of time, remove the battery from the
charger and unplug the charger's AC power plug from the outlet.
5