Automatic Heat Exchange Unit Temperature; Overlap Time Between Heat Production Units; Search, Setting And Supermaster Reset; Manual Modes - Airzone AZXCSMASTER Manual De Instalación Y Usuario



3.4.6. Automatic heat exchange unit temperature

*
*Only available with AZXCCPC and AZXSONDEXT[C/R]
If you want to activate the automatic heat production units exchange, you must define the
outside temperature at which you want to activate the unit exchange. The SuperMaster allows
 
modification of the temperature at values between º and º in 1º steps.

The default value is º.


3.4.7. Overlap time between heat production units

*
*Only available with AZXCCPC
In case of to change the heat production source (Pump or Boiler), the SuperMaster Controller
allows you to define an overlap time for the equipments that are working at the same time to
 
prevent efficiency loss. Overlap time can be defined at values between and minutes in 1

minute steps. The default value is minutes. During this time, the user screen will display the

 that indicates the system is in a heat stage change operation.
message


3.4.8. Search, setting and SuperMaster reset

*
*Only available with AZXCCPC
 
Menu allows you to search for systems or to check on the detected systems and

your configuration . Navigation and control parameters are those described at the initial
 
in
configuration (see section 3.3). It also allows you to reset the SuperMaster .Select
case you want to reset device. Resetting will delete all detected systems and programmes
created.
4. MANUAL MODE

4.1. Control group selection

The SuperMaster allows you to select up to 8 different control groups. It also has the option of
all groups . To select the control group you want to control, tap on the active control group on
the screen and all available control groups will appear. Then, tap on the group parameter that
you want to select (Fig.11).
Fig. 11
31