GYS MONOGYS 200-2CS Manual Del Usuario página 9

«SYNERGIC» MODE (FIG 6)
This function automatically controls the wire speed. There is no need to set the wire speed manually.
Position the wire speed potentiometer (3) in the middle of the« Optimal synergic » zone.
• Select:
- Wire type (1)
- Wire diameter (2)
- Power mode (4 position switch)
To select the right position in accordance with the thickness of the workpiece, please refer to the "synergic mode" table
on the previous page.
From the combination, the MONOGYS 185-2S determines the optimal wire speed and the device is ready to weld. It is
also possible to adjust the wire speed if necessary by adjusting the potentiometer + or – manually (3).
The last welding configuration is saved in the memory automatically
GAS (for steel welding) :
In synergic mode, MONOGYS determine the welding settings in accordance with the gas used. By default,
in steel welding the machine is set to « Argon + CO2 ».
To change the gas and set the machine to C02 mode or go back to Argon + CO2 mode :
1- Press « Type » for 5 seconds until the panel switches off, then release.
2- After 5 seconds, choose the required setting using the « mode » button.
• Normal (2T) => Argon + CO2 (default setting)
• Delay => CO2 100%
3- Confirm selection by pressing the « Type » button, or waiting 5 seconds.
4- Once confirmed, the machine reverts to the normal operating mode but the gas mode chosen will stay
selected, even when the machine is switched off.
DUTY CYCLE & WELDING ENVIRONMENT IN USE
The welding unit describes an output characteristic of «constant current» type. The duty cycles following the standard
EN60974-1 (at 40°C on a 10mn cycle) are indicated in the following table:
X/60974-1 à 40°C(T
cycle=10min)
MONOGYS 200-2CS
MONOGYS 250-4CS
Note: The machines' duty cycle has been tested at room temperature (40°C) and has been determined by
simulation.
• This is a A-class device. It is designed to be used in an industrial or professional environment. In a different environment,
it can be difficult to ensure electromagnetic compatibility, due to conducted disturbances as well as radiation. This device
complies with IEC 61000-3-12.
ADVICE & THERMAL PROTECTION
• Always respect the basic rules of welding.
• Do not block/cover the ventilation holes of the machine.
• Leave the device plugged in after welding to allow it to cool.
• Thermal protection: If the machine becomes too hot, the warning light will illuminate and the machine will stop. The
cooling time will be a few minutes; length of time will also depend on the external temperature.
MONOGYS 200-2CS • 250-4CS
I max 60%(T cycle=10min)
15% à 190A
15% à 210A
20% à 250A
100%(T cycle=10min)
110A
110A
155A
90A 230V
90A 240V
110A 240V
EN
9