Charging Stand - Remington Hyperflex XR1390 Manual Del Usuario

ENGLISH
C GETTING STARTED
It is recommended that you use your new shaver daily for up to four weeks to
allow time for your beard and skin to become accustomed to the new shaving
system.

, CHARGING STAND

• Rotate open the charge stand fully to stand firmly on a flat surface while
charging. For travel you can fold the stand around the shaver (see below).
, CHARGING YOUR SHAVER
• Ensure the appliance is turned off.
• Connect the charging stand to the adaptor and then to the mains.
• Place the shaver in the charging stand.
• Allow 90 minutes for a full charge.
• The LED display will indicate when the shaver is fully charged.
• When charge is low 'Lo' will appear on the screen and will flash until the
shaver is plugged in to charge. When charging, the LEDs blink in a clockwise
rotation. When fully charged the minutes remaining will show '60' minutes
• To preserve the life of your batteries, let them run out every 6 months then
recharge for 24 hours.
4