Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Changing the Length Units
MicroScanner
connected to the far end of the cable.
Ethernet port indicator. The speeds of the
port show under the indicator.
Wiremap diagram. The rightmost segments
indicate the shield.
W
The
the cable. SPLIT appears when the fault is a
split pair.
Changing the Length Units
Hold down
1
turning on the tester.
Press
2
and feet.
Auto Shutoff
The tester turns off after 10 minutes if no keys
are pressed and nothing changes at the tester's
connectors.
Testing Cabling
Press
1
MicroScanner
2
twisted pair (
Connect as shown in the following figures.
3
If the
8
2
: Indicates an ID locator is
indicates a fault or high voltage on
and
or
to switch between meters
to turn on the tester.
2
: Press
) and coaxial (
indicator appears, see page 11.
PoE
or
and
to switch between
while
) modes.
Publicidad
Tabla de contenido
