Changing The Unit Of Measure - Stanley TLM99 Manual Del Usuario

Subtracting Measurements
You can subtract one measurement from another.
1. Click (Figure #5) to turn on the tool.
A
2. The tool will measure the distance from the bottom
of the tool to the wall or object (Figure
To measure from the top of the tool instead of the
bottom (Figure #2), hold
F
On the display window, the tool icon will change
from to
3.
Point the laser at the top of the tool (Figure
toward the wall or object whose distance you need
to measure.
4.
Click to measure the distance from the tool to
the wall or object.
5.
Indicate that you want to subtract the next
measurement from this measurement.
• On the TLM99 keypad, click
• On the TLM99s or TLM99si keypad, click
twice.
6.
Point the laser at the top of the tool toward the next
wall or object.
7. Click to measure the distance and subtract it
from the previous measurement.
8. View the difference between the two measurements
at the bottom of the display window (Figure

Changing the Unit of Measure

Once the current measurement is taken (the device is
not in Continuous Measure mode), you can change the
unit of measure from decimal ft (6.21 ft) to fractional ft
(6'02" ), fractional ft to meters (1.894 m), meters to
9/16
inches (74 in), or inches to decimal ft.
9/16
• On the TLM99 keypad, click
• On the TLM99s or TLM99si keypad, hold
(Figure #1) until you see the measurement
B
change (2-3 seconds).
#1).
F
for 2 seconds.
(Figure #5).
E
#1)
A
twice.
#3).
E
(Figure #3).
A
Using the TLM99s/TLM99si With
If you have a TLM99s or TLM99si, you can use its
®
Bluetooth capability to pair it with the STANLEY
Smart Connect application on your cell phone or
tablet, and then record accurate measurements in your
floor plans.
1. From either
the STANLEY Smart Connect application to your
cell phone or tablet.
2. Using the STANLEY Smart Connect application,
capture the room or space for which you want to
record the measurements, and build your floor plan.
3. On the TLM99s or TLM99si keypad, click
turn on the tool.
®
4. If the Bluetooth icon does not appear on the
display window (Figure
keypad to turn on Bluetooth
5. Use the STANLEY Smart Connect application
to pair your cell phone or tablet to the TLM99s or
TLM99si.
6.
Use the TLM99s or TLM99si to measure each wall
in the room or space captured in the floor plan, and
sync the measurements to the floor plan.
7. Using the STANLEY Smart Connect application,
save the floor plan.
Once you have saved the floor plan, you can export it
to one of several different file formats, including PDF,
DXF, or JPG, and print it or email it to other people (your
realtor, home center, etc.).
"THE BLUETOOTH ® WORD MARK AND LOGOS ARE REGIS-
TERED TRADEMARKS OWNED BY BLUETOOTH SIG, INC. AND
ANY USE OF SUCH MARKS BY STANLEY TOOLS IS UNDER
LICENSE. OTHER TRADEMARKS AND TRADE NAMES ARE
THOSE OF THEIR RESPECTIVE OWNERS."
or , download
to
#6), click on the
E
®
.
GB
7