Breaking In The Pump - Husky H1820F-R Manual Del Usuario

ATTACHING HOSE AND QUICK COUPLER
Make sure the air compressor is off and unplugged.
Rotate pressure regulator knob fully counterclockwise.
Apply 1 layer of thread sealing tape to the threaded
end of the male coupler and insert into the air outlet
port on the compressor (Fig. 3).
NOTE: Be careful not to allow threads to become
cross-threaded.
At this point insert the hose into the quick coupler
already installed on the compressor (Fig. 4)
Firmly grasp the open end of the hose; hold facing
away from yourself and others.

BREAKING IN THE PUMP

See figure 5 - 6
Check and tighten all bolts, fittings, etc.
Turn the pressure regulator knob fully clockwise to
open the air flow.
Place the switch in the OFF position and plug in the
power cord.
Open the drain valve completely.
Turn the air compress ON ( l ) and run the air
compressor for 10 minutes to break in pump parts.
Place the switch in the OFF position.
Close the drain valve.
ASSEMBLY
ON/OFF SWITCH
13
REGULATOR
PRESSURE GAUGE
AIR OUTLET
PRESSURE
REGULATOR KNOB
SAFETY VALVE