Breaking In The Pump - Husky 2G110DP-R Manual Del Usuario

BREAKING IN THE PUMP

See Figures 3 - 4.
Check and tighten all bolts, fittings, etc.
Turn the pressure regulator knob fully clockwise to
open the air flow.
Place the switch in the OFF position and plug in the
power cord.
Open the drain valve completely.
Turn the air compress ON ( l ) and run the air
compressor for 10 minutes to break in pump parts.
Place the switch in the OFF position.
Close the drain valve.
WARNING:
Do not attach any tools to the open end of the hose until
start-up has been completed.
ASSEMBLY
PRESSURE
REGULATOR
KNOB
12
ON/OFF
SWITCH
REGULATOR TANK
PRESSURE PRESSURE
GAUGE GAUGE
DRAIN VALVE
SAFETY
VALVE
Fig. 3
Fig. 4