Bestway Tritech Collada P5773 Manual Del Usuario página 2

USB Powered Night Stand Light
P5773
DC 3.7V 0.5W
WARNING:
READ AND FOLLOW ALL INSTRUCTIONS.
SAVE THESE INSTRUCTIONS.
The light source of this luminaire is not replaceable; when the light source reaches its end of life
the whole luminaire shall be replaced.
Any changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/ TV technician for help.
Performance and parameter
1. Comparable to 5 LED lights of high light intensity.
2. Global standard USB charging port provides long-life light time, 4-5 hours to fully charge.
3. Built-in 1800mAh polymer lithium battery nominal voltage is 3.7V.
4. Built-in battery provides up to 10-15 working hours.
5. Slightly press the switch to light on or off.
6. Built-in strong magnet adsorption located on the bottom base, can adhere to iron pieces.
Note:
1. Do not use it under the circumstance of over 60℃ or below -30℃ extreme environment.
Otherwise the life span of the LED light and battery becomes shortened substantially.
2. Do not use it in water, otherwise it may cause faulty circuit due to possible leak.
2