Publicidad
Idiomas disponibles
Idiomas disponibles
Attention: Maintenance work presents the risk of crushing the fingers due to high mag-
netic forces.
Do not clean the unit – or parts of it – in the dishwater. Not dishwater resistant!
Do not dispose of this product as normal household waste. Take it to your local refuse
collection site.
A
Function
Motor body with sealing ring
2000 /3000: pump wheel, axle with sleeves (Model 5000: pump wheel unit)
screws
Coarse filter
side
2 fastening strips for suction unit
Holder with brackets, screw clamps and stop screws.
B
Installation
Attach the two fastening strips to the bottom of the motor body and hang the pump into
the brackets
. The screw clamps of the holders can be inserted in two versions. The
stop screws allow the vertical position of the pump to be adjusted exactly.
When the pump is mounted horizontally (drawing E) the four suction grips are placed
on the fastening strips. Place the pump on the desired position.
C
Start-up
Plug the mains plug to start the pump. Turn the output regulator from min. to max. to
adjust the flow quantity as required.
The pump should not run dry. Temperature range from +4°C up to max. +35°C.
The motor is protected from overheating.
The pump can be used in or out of water. The pump does not automatically take in water.
Therefore, it must be placed below the level of the water surface if it is used out of water.
Before start-up the water circulation must be set going by suction. If the pump is used
out of water, the pump is used with a hose fitted to the supplied connection pipe.
C
In this case remove the suction grid from the pump and press the cover out.
1
C
Screw the hos connection on to the pump housing and ensure that the sealing
2
disk is positioned properly.
C
Fit the suction grid on to the pump again.
3
C
Fit the hose on to the hose connections and secure it with the hose straps in-
4
cluded.
The product is qualified in accordance with the respective national reg-
ulations and guidelines and meets EC standards.
Suction grid
Pump housing
Cover
Hose connection on the suction
4 suction grips
Output regulator
2 hose straps
Model
4
Publicidad
