Set-up and Assembly
2. Assembling the footrest
Position the foot rest in front of the seat and connect the air hose and plug to the counterpart on
•
the seat (Figs. 1 + 2).
Then push any protruding air hose and cable back into the seat.
•
Fig. 1
Slide the inner and outer sleeves onto the mounting bracket on the footrest. Check that the head
•
end is facing the footrest (Fig. 3).
On the inner side of the seat, open the hinges on the right and left (Fig. 4).
•
Fig. 3
Hang the footrest with the sleeves into the hinges (Fig. 5)
•
Close the hinges and secure them using an M5 screw. (Fig. 6)
•
26
Set-up and Assembly
Then place the plastic covers over the hinges. (Fig. 7)
•
Fig. 2
3. Assembling the touchscreen bracket
Insert the holder into the side panel and secure it using 3x M4 screws. (Figs.1+2).
•
Fig. 4
Fig. 5
Fig. 7
Fig. 1
Fig. 6
Fig. 2
27