Cleaning | Maintenance | Storage - Casada braintronics SKYLINER II Manual De Instrucciones

Set-up and Assembly
7. Repositioning the massage chair
Make sure no cables are lying across the floor. Tilt the backrest somewhat backwards (with the
•
centre of gravity on the wheels). Use your hands to push the chair forwards or backwards, then
return it to its original position slowly and gently.
NOTE: Before moving the chair, you must first switch it off and then disconnect the power cord
and the connecting cable.
NOTE: Please do not move the chair alone. The second person can lift the chair at the front to
position it onto the rollers.
30

Cleaning | Maintenance | Storage

A|
CLEANING THE SYNTHETIC LEATHER
Wipe the synthetic leather with a soft, dry cloth. Please do not clean with products which con-
tain chemicals, such as thinners, benzine and alcohol. Make sure that the cleaning agents do not
damage the synthetic leather. Please read the instructions on the cleaning agent very carefully. If
the synthetic leather is very dirty, clean it as follows:
1. Moisten a soft cloth with hot water or a commercially-available neutral detergent and
wring it out.
2. Check that the cloth has been well wrung out.
3. Clean the surface of the synthetic leather with the cloth.
4. While cleaning, make sure that you rinse the cloth several times.
5. Leave the synthetic leather to dry naturally. Do not use a hairdryer.
The surface of the synthetic leather may fade or discolour if an unsuitable cleaning agent is
•
used. Before using any cleaning solution on the entire surface, test it first on a small section.
Cleaning the synthetic leather with alcohol, thinner or petrol-containing agents may lead to
•
discoloration or even remove the paint.
B|
CLEANING THE PLASTIC PARTS
1. Put a soft cloth in warm water with a neutral detergent, wring out well and wipe off the plastic
parts.
2. Do not use chemicals, such as thinners, benzine and alcohol to clean the plastic parts.
3. Wipe with a microfibre or soft cloth wrung out in clean water.
4. Allow the plastic parts to air dry.
C|
STORAGE
If the device is not used for a longer period of time, the power cable should be wound up and
•
the device should be stored in a dry environment.
Never store the device at high temperatures or in proximity to open fire. Avoid prolonged
•
exposure to sunlight.
When cleaning, only use commercially-available products for synthetic leather. Never clean it
•
with thinner, benzene, or alcohol.
If the device is on an uneven surface, do not roll or push it; lift it up in order to move it.
•
Please take breaks after each use and do not use the device a number of times without pauses.
•
31