Pc Troubleshooting - Thrustmaster Enzo Ferrari 2-in-1 Racing Wheel Manual Del Usuario

Note: If you can't recall whether you have installed the patch on your computer or not, you can check this
by verifying the name of your controller in the Windows Control Panel > Game Controllers section:
- If the patch hasn't been installed, your Enzo 2-in-1 wheel will appear as "Enzo PC-PS2 RW"
- If the patch has been installed, your Enzo 2-in-1 wheel will appear as "Thrustmaster Enzo PC-PS2 Racing
Wheel".
Enabling/disabling vibration (PS2 only)
Access your racing game's controller options, and select "Vibration on" or "Vibration off".
Note: Vibration function is not available on PC!
Wheel sensitivity (PS2 only)
"High sensitivity" is the default setting for your wheel (i.e. no "dead zone" when the wheel is centered). To
set your wheel to "low sensitivity" (i.e. with a "dead zone" located at the wheel's central position), press the
Select (5) and Start (6) buttons simultaneously (the Mode LED glows green). To revert to the "high
sensitivity" setting, repeat the operations above (the Mode LED glows red).
Mapping (PS2 only)
Disconnecting the pedals
The Enzo 2-in-1 wheel allows you to play without using the pedals – the two analog levers will then be
allocated to accelerator and brake controls.
- PS2: Disconnect the pedals then simply press the PS2:On/Off button in order to reset the wheel.
- PC: First disconnect the pedals, then connect the wheel to your PC's USB connector.

PC TROUBLESHOOTING

My wheel is not detected by my computer
- Unplug the USB connector and then plug it back in again.
My wheel is detected by my computer but doesn't work in the game
- Access your game's options to configure your wheel. Please refer to your game's manual for further
information.
My wheel doesn't work correctly or appears to be incorrectly calibrated:
- Exit the game, then disconnect your wheel for your PC's USB connector and plug it back in again.
Note: Do not turn your wheel or press any of its buttons after reconnecting it to your PC!)
- Install the patch named Wheelpatch.exe on your PC and try to reconfigure your wheel in your game's
Controller options (if your wheel's 3-axis mode seems incompatible, try activating the 2-axis mode).
FAQs, tips and drivers available at www.thrustmaster.com
3/4