Loading Batteries - Uline SCOTT PRO H-9550 Guia Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5. Slowly lower the gray bar until it is seated on the
paper. Do not slam bar down. (See Figure 7)
Figure 7
6. Load the new towel roll into upper roll holders so the
paper feeds down from the back. (See Figure 8)
7.
Lift the black transfer bar and place the leading
edge of the paper under it and on top of the
existing paper sheet. Slowly release the transfer bar.
(See Figure 8)
8. Wrap the leading edge of the paper up and around
the black transfer bar and pierce the paper on the
center hook on the transfer bar so it is held in place.
(See Figure 8)
Figure 8
9. Leave some slack in the main roll to ensure proper
transfer. Close cover securely.
NOTE: Following cover closure, there is a
four-second delay before unit is activated.
10. The stub roll will continue to dispense until it is empty,
at which time the main roll will begin to feed.
PAGE 3 OF 15
LOADING CONTINUED

LOADING BATTERIES

1.
When battery power is low, the red "Low Battery"
light will flash.
2. Grasp battery box tab and pull upward.
(See Figure 9)
Figure 9
3. Remove spent batteries if present.
4. Insert new "D" size batteries and close battery box
cover securely. (See Figure 10)
Figure 10
0921 IH-9550

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Scott pro h-9551

Tabla de contenido