Indicator Lights - Uline SCOTT PRO H-9550 Guia Del Usuario

ADJUSTING THE ACTIVATION SENSITIVITY
To adjust the activation sensitivity, set the switch to the
upper (low sensitivity) or lower (high sensitivity) position.
Do not set the switch in the middle position as the unit
will turn off. (See Figure 11)
NOTE: For installations over counters, trash
receptacles, etc., the activation sensitivity must
be set on the low setting.
ADJUSTING THE SHEET LENGTH
To set the length of the sheet that is dispensed, set the
slide switch to the upper (8"), middle (10") or lower (12")
position. (See Figure 11)
SETTING THE OPERATING MODE
The dispenser is designed to function in either
the "Hidden" or "Hanging" mode. To select the hidden
mode, slide the switch to the upper position. To select
the hanging mode, slide the switch to the lower position.
(See Figure 11)

INDICATOR LIGHTS

The "Low Battery" indicator light will begin to blink red
when the battery life is getting low and the batteries
should be changed soon. The light will glow red
constantly when the batteries have reached the end of
their useful life, and should be changed immediately.
(See Figure 11)
The "Low Product" indicator light will blink yellow when
the product roll can be moved to the stub roll position.
(See Figure 11)
Figure 11
Activation
Sensitivity
Adjustment
Low Battery
Indicator
PAGE 4 OF 15
Sheet Length
Adjustment
Operating
Mode Selector
Low Product
Indicator
OPERATION
JAM ALERT
In the event of a paper jam, the "Low Battery" and "Low
Product" lights will flash red and yellow alternately. While
it may be possible to clear a jam from outside, the
dispenser may need to be opened to clear the jam.
LENS INSTALLATION
1. Clean the area around the circular opening on the
outside of the dispenser cover with an alcohol wipe.
2. Remove the red adhesive liner from the lens.
(See Figure 12)
Figure 12
3. Press the lens onto the cover and maintain pressure
for 10 seconds. (See Figure 13)
Figure 13
0921 IH-9550