2
Safety and security
2.1
General safety advice
DANGER!
If you believe that the unit can no longer be operated safely, you must
decommission it immediately and secure it so that it cannot be used
inadvertently.
This applies:
– if the unit shown visible signs of damage;
– if the unit no longer appears to be operational,
– after prolonged periods of storage under unfavourable conditions
(perform functional check).
The following regulations must always be observed when handling
the system:
– Before any work takes place on electrical parts, the system must be
disconnected from the power supply and protected against being
switched back on.
– Safety regulations and prescribed protective clothing when handling
chemicals should be followed.
– Attention must be paid to the information included on the product data
sheet for the metering medium used.
– The system must only be operated with the supply and control voltage
specified in the Technical Data section.
2.2
Intended Use
WARNING!
This device is intended only for measuring validated liquids.
This device was developed, designed and built for industrial and
commercial use. The unit is not intended for private use.
Any use which extends beyond or differs from the appropriate use is
considered improper use!
CAUTION!
The intended use also includes compliance with all prescribed by the
manufacturer operating and operating instructions as well as all service and
maintenance requirements.
WARNING!
Danger of misuse!
Improper use may result in dangerous situations:
– Never use liquids if they are not validated.
9
Safety and security
417102396 Rev. 1-10.2019