Basic Operation - Toshiba MMY-MAP0806HT8P-E Manual De Instrucciones

12
2
5
3
11
button (Unit/Louver select button)
Selects a unit number (left) and louver number
(right).
UNIT button:
If two or more indoor units are controlled by one
remote controller, use this button to select a unit
to adjust its air blow direction.
LOUVER button: (4-way cassette type only)
Selects a louver to control when adjusting the
louver lock setting or wind direction setting
separately for each louver.
12
button
Adjusts the set temperature.
Select the desired set point by pushing TEMP.
or .
OPTION:
Remote controller sensor
Normally the temperature sensor of the indoor unit
senses the temperature. The return air temperature
around the remote controller can also be sensed. For
details, contact your dealer.
* Do not use the function when the air conditioner is
controlled in a group.
69-EN
1117102201-2_EN.indd 35 1117102201-2_EN.indd 35
1 8
9
10
4
11
7 6
– 35 –
4

Basic operation

• When you use the air conditioner for the fi rst time or change the settings, follow the procedures below.
From next time, pushing the button starts running of the air conditioner with the chosen settings.
■
Preparation
Turn on the power switch
• When turned on, the separation line appears and
* The remote controller will not work for about 1 minute after turning on the power. This is not a
malfunction.
REQUIREMENT
• Keep the power switch turned on during use.
• When you resume using the air conditioner after a long period of disuse, turn on the power switch at least 12
hours before starting running.
■
Operations
TEMP. ON / OFF 1, 3
TIMER SET FAN MODE 2
TIME SAVE VENT
FILTER
RESET TEST SET CL SWING/FIX UNIT LOUVER
1
Push the button.
The operation lamp lights up.
2
Push the "MODE " button to select a
operation mode.
Each time you push the button, the operation
mode and its icon change in the following order:
Heat-pump model
Heat Dry Cool Fan
(Dehumidify)
Cooling only model
Dry Cool Fan
(Dehumidify)
" Dry" is not available for the concealed duct
high static type.
blinks on the remote controller display.
3
Push the button to stop running.
The operation lamp turns off.
■
Changing the fan speed
1
Push the "FAN " button to select a fan
speed.
• Each time you push the button, fan speed and
its indication change in the following order:
(" Auto" cannot be selected in the FAN
mode.)
Auto High Medium Low
• When heating, if the room does not heat
up using " Low", select " High" or "
Medium".
• The temperature sensor detects the return
air temperature at the indoor unit, which may
slightly differ from the actual room temperature
depending on installation condition. Set
temperature is a target of room temperature.
• The fan speed selection function is not
available for the concealed duct high static
type. Fan speed is fi xed and the indicator is
fi xed to " High"
6/30/2559 BE 15:41 6/30/2559 BE 15:41
70-EN