Safety Instructions - cecotec FAST&FURIOUS 5010 VITAL Manual De Instrucciones

SAFETY INSTRUCTIONS

Read these instructions thoroughly before using the appliance.
Keep this instruction manual for future reference or new users.
All safety instructions should be closely followed when using
the appliance.
Make sure that the mains voltage matches the voltage stated
on the rating label of the appliance and that the wall outlet is
grounded.
Do not immerse the cord, plug, or any non-removable part
of the appliance in water or any other liquid, nor expose the
electrical connections to water. Make sure your hands are dry
before handling the plug or switching on the appliance.
If the appliance falls accidentally in water, unplug it
immediately. Do not reach into the water!
Do not twist, bend, strain, or damage the power cord in any
way. Protect it from sharp edges and heat sources. Do not let
it touch hot surfaces. Do not let the cord hang over the edge of
the surface.
This appliance is not intended to be operated by means of an
external timer or separate remote-control system.
Turn off and unplug the appliance from the mains supply when
not in use and before cleaning it. Pull from the plug, not the
cord, to disconnect it from the outlet.
This appliance is designed to iron textiles. It is designed for
domestic use only and, therefore, not suitable for commercial
use. Do not use outdoors.
To protect against burns or injuries to persons, do not iron
textiles while being worn on the body.
Do not use any accessory that has not been recommended by
Cecotec, as they might cause injuries or damage.
This product can be used by children and persons
with reduced physical, sensory or mental capabilities
or lack of experience and knowledge, as long as they have
been given supervision or instruction concerning the use of the
appliance in a safe way and understand the hazards involved.
Place the appliance on a dry, stable, flat, heat-resistant surface.
The temperature of accessible surfaces may be high while in
use and could cause burns. Do not touch hot surfaces while in
use or immediately after.
Unplug the appliance immediately if fire or smoke is observed.
Do not leave the product unsupervised during operation.
Unplug the device after use and when you leave the room
where it is installed.
The appliance must not be plugged in when filling or emptying
the water tank.
The tank cap must not be open when the appliance is switched
on.
The use of tap water is recommended. If the lime content of the
tap water is too high, use a mix composed of 50 % of tap water
and 50 % of water with low mineral content. Do not use only
water with low mineral content.
Burns can occur when touching hot metal parts, hot water, or
steam. Hot water may leak from the iron.
Be careful when filling or turning the steam iron upside down.
To protect against burns or injuries, do not direct steam toward
persons or animals when ironing.
The iron must be used and placed on a stable surface. When
placing the iron on its stand, make sure that the surface is
stable.
Keeping the iron at maximum temperature for too long may
cause discolouration, which will not affect the performance of
the appliance.
Do not try to repair the device by yourself. Contact the official
Technical Support Service of Cecotec for advice.
Cleaning and maintenance must be carried out according to