Toshiba ССD Manual De Instrucciones página 12

Indoor unit cassette type
3.
The length of suspension bolts must be appropriate for a distance between the bottom of the
bolt and the bottom of the unit of more than 15mm as shown in Fig.8
Fig.8
4.
In order to prevent a possible looseness, it is recommended to use 3 hexagonal nuts (Prepared
on site) and 2 washers (accessory) for each suspension bolt. Pay attention that 2 nuts will be
used in the lower side.(Fig.9)
5.
Adjust the distance between the unit and the ceiling bottom to 10~12mm. Tighten all the nuts
on the suspending bolts.(Fig.9)
Nuts and washers
(Use for upper and lower)
Fig.9
Supplied bolt
Full-scale installation diagram
(Supplied with the unit)
Suspension bolt
2 nuts
Suspension hook
10 12 mm
11