Technical Specifications; Putting The Machine Into Service - Grillo FM13.09 Uso Y Mantenimiento

MODEL: hydrostatic lawnmower with front deck.
ENGINE: YANMAR 3TNV82, diesel 1331 cm³ (31 HP at 3000 revolutions), 3 cylinders, liquid cooling system with
electric fan, equipped with manual and automatic radiator clearing device.
FUEL TANK: 25 litres.
HYDRAULIC OIL TANK: 20 litres.
STARTER: electric 12V.
TRACTION: hydraulic, 4 drive wheels (integral and permanent also in case of sharp bend).
DIFFERENTIAL LOCK: AUTOMATIC AND MANUAL WITH PUSH BUTTON.
GEARBOX: hydrostatic transmission with 4 hydraulic engines on 4 wheels.
STEERING SYSTEM: hydraulic drive with steering wheel.
CLUTCH: electromagnetic for PTO, with magnetic blade brake.
SPEED: 0-15 km/h: continuous variation.
WHEELS: front 23 x 10.50-12; rear 18 x 8.50-8.
BRAKE: drum service and parking brake.
HYDRAULIC DECK LIFTING .
2 X HYDRAULIC ATTACHEMENTS FOR INTERMITTENT USE: max. pressure:120 bar, max. oil flow 18
litres/minute with engine at 3000 rpm.
SEAT: super comfort adjustable and sprung seat with arm-rests.
STEERING WHEEL: fixed on steering column with tilt adjustment.
STEERING RADIUS: 310 mm.
ATTACHMENTS: 130 cm MP cutting deck, 160 cm LMP cutting deck,135 cm all purpose flail, 150 cm front blade,
comfort cabin with heating, snow chains, pneumatic dampened seat.
HOURLY MOWING CAPACITY: 12.000 m
SIZE (with 160 cm LMP cutting deck):
Length: 3250 mm, Width: 1920 mm, Height: 1750 mm.
CLEAR SPAN FROM THE GROUND: 150 mm.
DISTANCE BETWEEN AXLES: 1220 mm.
WEIGHT (without cutting deck): 932 kg.
Make sure the machine is complete and that it has not suffered any damage during transit.
- Check the levels of the engine oil (fig. 4) and hydrostatic transmission (fig. 35).
- Check the tyre pressures:
Front wheels 23 x 10.50 - 12 (1.4 bar)
Rear wheels 18 x 8.50 - 8 (1.4 bar)
Deck wheels (1.5 bar)
Check the battery voltage, it must not be less than 12.5 Volts; recharge if necessary.
If a dry battery has been supplied with separate acid, to put the machine into service proceed as follows:
1) pour in the acid and wait 2 hours;
2) charge the battery with a charger set to 12 Volts on a slow charge for 2 hours.
Caution, if this procedure is not observed this could lead to the battery deteriorating and the acid leaking out
during work.
BATTERY
Caution! The gases released by the battery are explosive, so keep it away from naked flames or sparks. Check the
level of the liquid at regular intervals and keep the terminals greased with Vaseline.
Important:
Do not invert the battery poles.
Do not run the lawnmower without the battery, as it is equipped with a charge regulator.
Be careful not to cause any short circuits.
RUNNING IN - CAUTION!!
Change the engine oil and filter after the first 50 hours of work.
Check for oil leaks or loose screws, especially those that retain the blades and the wheels. Adjust the tension on the
PTO belts with the nut on the corresponding spring: the spring has to be adjusted at 65 mm of length from bushing
to bushing (see red arrow - fig. 5, ref. A).
Translation of the original instructions

TECHNICAL SPECIFICATIONS

2 /h

PUTTING THE MACHINE INTO SERVICE

7