Vehicle Preparation - BMW F 46 84 051 B Instrucciones De Instalación

Roof antenna D-network BMW 3 Series saloon (E46/4)
Intended for use in BMW dealership organisation only.
Installation time approx. 1.5 hours which can vary
depending on the condition and equipment of the
vehicle. Knowledge of the body electrical system is
required.
b
Particular care must be taken during installation
in the vehicle to ensure that cables and wires are not
kinked or damaged.
Vehicles can be driven through a carwash system
without having to dismantle the roof antenna.
Ensure the roof headlining is not bent or kinked during
removal. Assistance of second person is advisable.
Deburr drilled holes and treat with anticorrosion paint
in accordance with BMW standard.
Subject to technical modifications.
Required tools and other equipment:
Set of screwdrivers for recessed crosshead screws
Set of warding files
Open-ended spanner WAF 20
1/4 inch set of sockets
Inspection lamp
Side cutter
Power drill
Twist drill 3 mm Ø
Water-soluble marker
Protective goggles
Textile adhesive tape
Masking tape
Step drill 4 - 20 mm Ø
Anticorrosion paint
Tape measure
2. Overview of Installation Kit
F 46 84 052 B
Item
1 Antenna rod
2 Antenna base
3 Antenna cable
4 Cable tie
6
c
Description
Contents
Section
1.

Vehicle Preparation

2. Overview of Installation Kit
3. Drilling Hole for Antenna
4. Mounting Antenna Base
5. Installing Antenna Cable
6. General Information
1. Vehicle Preparation
– Remove left-hand boot trim panel
– Remove rear bench seat and rear backrest, on
vehicles with split rear backrest, remove left side
section of rear backrest
– Remove C-pillar trim panels
– Remove covers for raised brake light
– Remove raised brake light
– Remove rear grab handles
– Carefully release roof headlining from rear
retaining strip
– Lightly pull down headlining (remove sound
deadner mat if fitted)
Qty
1
1
1
5