Tool Use And Care; Specific Safety Rules - Urrea GGI810 Manual De Usuario

TOOL USE AND CARE

Do not force the power tool. Use the correct
tool for the application. The correct tool will do
the job better and more safely at the rate that it
was designed to work at.
Do not use tools if switch does not turn it on or
off. Any tool that cannot be controlled with the
switch is dangerous and must be repaired.
Disconnect the plug from the power source be-
fore making any adjustments, changing acces-
sories or storing the tool. This preventive safety
measures reduce the risk of accidental starting
of the tool.
When the power tool is not in use, store it out
of the reach of children, and do not allow in-
dividuals who are not familiar with the power
tool or these instructions to operate it. Power
tools are dangerous in the hands on untrained
users.
Maintain the power tool. Check for misalign-
ment or binding of moving parts, broken parts,
and any other condition that may affect the
operation of the power tool. If it is damaged,
have it repaired before using. Many accidents
are caused by poorly maintained power tools.
Check for misalignment or bonding of moving
parts, breakage parts, and any other condition
that may affect the tools operation. If you find
a damaged tool, take it to service before use it.
Use only accessories that are recommended by
the manufacturer of your model. Suitable ac-
cessories for one tool, may become hazardous
when are used on another tool.
Keep cutting tools, sharpened and clean. Cut-
ting tools in good condition with sharpened
edges, are less likely to stuck in workpieces or
easier to control.
It is reccomended to use a safety device suitable,
such a thermal and differential switch when you
are using an electric equipment.
SERVICE: Tool service must be performed only
by qualified repair personnel. Service or main-
tenance performed by unqualified personnel
could result in a risk of injury.
E N G L I S H •

SPECIFIC SAFETY RULES

DANGER¡ Failure to follow these instructions
and warnings may result in death, personal in-
jury or property damage.
• Read carefully and understand the opera-
tor's manual before using this product. Fol-
low all warnings and instructions.
• Know your equipment. Consider the ap-
plications, limitations and potential risks
specific to your unit.
• The equipment must be placed on a firm
base.
• The electrical load supported by the gener-
ator must be kept within the nominal val-
ues shown on the data plate. An overload
will damage the unit or shorten its life.
• Do not must run the engine at excessive
speeds. Operating the engine at excessive
speed increases the risk of physical injury.
Do not touch or replace parts that may
increase or decrease at a regulated speed.
• To prevent accidental starting, always re-
move the spark plug or spark plug wire
before servicing the generator or engine.
• Never operate the unit if it has broken or
missing parts. Contact your service center
to request replacement parts.
• Units should not be operated or stored in
damp or wet or highly conductive locations
such as metal platforms or steel structures.
• Keep the generator clean and free of oil,
mud or any other foreign material.
• Extensions, electrical cables and all electri-
cal equipment must be in good condition.
Never operate electrical equipment with
damaged or defective cables.
• Store the generator in a well-ventilated
place, with the fuel tank empty. Fuel
should not be stored near the generator.
• Your generator should never be operated
if the following happens:
• The engine speed changes suddenly
and uncontrollably.
• Loss of electric charge.
• Overheating of the connected equip-
ment.
• Sparks formation.
• Damaged receptacles
• Failure to turn on.
• Excessive vibration.
• Flames or smoke.
• Closed compartment.
• Rain or inclement weather. Do not let
the unit get wet when it is working.
U s er 's M an u al
15