Jeep Liberty 2002-2007; Jeep Wrangler 2003-2006; Kit Assembly; Din Radio Provision - Metra 99-6503 Instrucciones De Instalación

Dodge Dakota 2001-2004
/ Durango 2001-2003
1.
and remove the top
Remove (3) T-20 Torx
half of the shroud.
screws from the bottom
edge of the panel below
4. Unsnap and
the steering column and
remove entire panel
unsnap to remove panel.
surrounding radio,
2. Remove (2) Phillips A/C controls, and
screws from the instrument cluster.
instrument cluster
5. Remove (4) Phillips
panel above gauges.
screws securing
3. Remove (3) T-20
radio. Disconnect
Torx screws from and remove radio.
the bottom of the
Continue to kit
steering column
assembly
shroud and unsnap
2 Screws
2 Screws
3 Screws
3 Screws
3 Screws
3 Screws
(Figure A)
METRA - The World's best kits
Installation instructions for part 99-6503

Jeep Liberty 2002-2007

1. Remove ashtray and
remove one Phillips
screw exposed.
2. Unclip and remove radio/
climate control panel.
3. Remove (4) Phillips
screws securing radio.
Disconnect and remove
radio.
Continue to kit assembly

Jeep Wrangler 2003-2006

1. Unsnap and remove
defroster grille panel
near windshield.
2. Remove (2) Phillips
screws exposed at the
top of the center dash
panel and unsnap and
remove panel.
3. Remove glove box
door to access one
10mm nut on back
of radio.
® metraonline.com
®
1. Remove the metal
2. Slide the sleeve into
2 3
1 4
POWER
OUTLET
3. Slide the radio into the
(Figure A)
4. Locate the factory
4. Remove (4) Phillips
screws securing
radio. Disconnect and
remove radio.
Continue to kit
assembly
(Figure A)

Kit Assembly

99-6503

DIN radio provision

recommends using the
DIN sleeve from the proper mating adapter
aftermarket radio. from Metra or AXXESS.
Test the radio for proper
operation.
the radio housing and
5. Reassemble the dash
secure by bending
the metal locking tabs in reverse order of
down. disassembly. (Figure A)
sleeve until it clicks in.
(Figure A)
wiring harness in
the dash. Metra
(Figure A)
IMPORTANT
If you are having difficulties with the installation of this
product, please call our Tech Support line at 1-800-253-
TECH. Before doing so, look over the instructions a second
time, and make sure the installation was performed exactly
as the instructions are stated. Please have the vehicle apart
and ready to perform troubleshooting steps before calling.
K P
NOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
© COPYRIGHT 2016 METRA ELECTRONICS CORPORATION
Metra recommends MECP
certified technicians