Cosatto the ABCs woosh double Manual De Instrucciones página 7

Hood 27-
28-
29-
Bumper bar caps 30-
31-
Bumper bar 32-
33-
34-
Bumper bar cover 35-
Raincover 36-
Bell 37-
Seat cover 38-
Seat boards 39-
40-
Pushchair 41-
Using the hood pocket:
Using the viewing window flap:
Removing:
Refitting is a reversal of this procedure.
Removing:
Fitting:
Fitting:
Opening:
Removing:
Removing:
Refitting is a reversal of this procedure.
Fitting:
Removing is a reversal of this procedure.
Operating:
Removing:
Remove the bumper (refer to step 34) & hood (refer to step 29) respectively.
Release the fabric fastener on the underside of the calf support (a).
Release the strap under the seat (b).
Release the tabs on both side of the seat section: Two on the outward side (c) &
one on the inward side (d).
Release tabs on both side of the backrest section (e).
Push down the backrest strap end to expose the opening of the «C» ring (f ) and
slide the strap out of the ring (g).
Remove the seat cover off the seat (h).
Prior to cleaning the seat cover, remove the harness (refer to step 16), seat
board (a) & backrest board (b).
Refitting is a reversal of this procedure.
Important: The backrest strap must be fitted correctly as illustrated.
Closing:
Close the hood fully (refer to step 24) (a).
Slide the primary lock lever (b) and rotate the secondary lock handle forward
FULLY (c) to unlock the chassis.
Push the handle downwards (d) until the chassis is locked in place (e).
4