Publicidad
Important! The fitting must be installed, flushed
and tested after the valid norms!
Assembly
The hot and cold supplies must be of equal
pressures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
The flow is changed from bath to shower function
by pulling the knob at the upper side of the spout.
After shutting off the water flow, the mixer returns
automatically to the bath function.
Technical Data
Operating pressure:
Recommended operating pressure:
MPa
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Rate of flow:
anti-pollution function
max. 1 MPa
0,1 – 0,5
1,6 MPa
max. 80° C
60° C
ca 22 l/min 0,3 MPa
English
To adjust the hot water limiter on single lever
mixers, please see page _1b.
No adjustment is necessary when using a
continuous flow water heater.
Hansgrohe single lever mixers can be used
together with hydraulically and thermically
controlled continuous flow heaters if the flow
pressure is at least 0,15 MPa.
Spare parts see page 4
1
handle
1.1 screw cover
2
flange
3
nut
4
cartridge cpl.
5
spray former cpl.
6
selector assy
7
diverter knob
8
non return valve
9
hose
10
filter packing
11
hand shower
10490000
96338000
96395000
96461000
92730000
97467000
94077000
96466000
94074000
28282000
94246000
28531000
9
Publicidad
