De Dietrich FM161 Instrucciones De Instalación página 22

3.2 Outside radio-controlled temperature sensor
Each outside temperature sensor is given a unique identification
number in the factory, which enables the transmitter/receiver box to
recognise it. This identification number is transmitted to the
transmitter / receiver box by the pairing sequence described below.
When no remote control or radio-controlled outside
temperature sensor is paired with the transmitter/receiver
module, the light flashes slowly (once per second).
Troubleshooting
Status of the warning light on the transmitter/
receiver box
Warning light on at start-up
The warning light flashes slowly at start-up
The warning light flashes rapidly
Warning light on after the pairing button has
been pressed
The warning light is pulsing
22
- Switch the boiler off and switch back on
- If the problem persists, contact the fitter. The transmitter/receiver box is damaged.
- No remote control or outside temperature sensor is paired with the transmitter/receiver
module.
- If rapid flashing does not stop after 10 seconds after switching on, a CDR2 remote control
is paired with a circuit which is already paired with a CDI2 (FM51) or FM52 remote control.
Re-pair the CDR2 remote control with another circuit or change the CDI2 (FM51) or FM52
remote control on the circuit.
- The transmitter/receiver module is in pairing mode with the CDR2 remote control or an
outside temperature sensor. This mode remains activated for a maximum of 2 minutes.
See previous page.
- A communication has taken place between the transmitter/receiver module and the CDR2
remote control or an outside temperature sensor.
FM161 - FM162 - AD241 - AD242
The pairing must be done in the boiler room on first
initialisation.
Press the button on the transmitter / receiver box using a pen.
The light on the transmitter/receiver box comes on.
Press the button on the outside temperature sensor.
The light on the outside temperature sensor comes on. The
light goes off briefly every 3 seconds when the sensor
transmits the outside temperature to the transmitter/receiver
module.
After a few seconds, the light on the transmitter/receiver box
goes off. The light comes on briefly every 3 seconds to confirm
reception of the outside temperature. To exit this mode, press
the button on the outside temperature sensor.
The outside temperature sensor automatically exits the pairing
mode after 5 minutes. The transmitter/receiver module exits the
pairing mode after 2 minutes.
A DIEMATIC 3 control panel awaits reception of the outside
temperature when the appliance is switched on. This operation
may take up to 3 minutes. If no outside temperature sensor is
connected, an error message is displayed.
To cancel the pairing of all circuits and the outside temperature
sensor, press the push button on the transmitter/receiver box
for 10 seconds (until the light goes off).
Meaning / Solution
14/05/08 - 300009547-001-C