Eldom fitto BLP10 Manual De Instrucciones página 10

Do not exceed the maximum time of continuous
operation of the device. Any failure to comply with the
above, as well as any failure to keep the device idle for
the required time may irreparably damage the motor.
If the blade (C) becomes blocked, immediately switch
the blender off, disconnect it from the mains, and allow
it to cool down for at least 15 minutes. Remove the
blocking object.
- Before removing the container (B) from the base (E),
wait for the blade to stop.
- Rotate the container (B), place it on a flat surface and
unscrew the blade (C).
- Pour the contents of the container into a glass or
attach the cap (A). The cap (A) is equipped with a
handy mouthpiece with a plug, and a handle (fig. 5).
CLEANING AND MAINTENANCE
The device is easiest to clean immediately after use.
Before cleaning, switch the device off, pull out the plug from the mains socket and wait for the blade (C)
to stops rotating.
Do not use abrasives, powders, acetone, alcohol, etc for cleaning.
Clean the components with a brush and warm water with some detergent. Rinse with running water.
Pay attention during cleaning the blade (C). It is very sharp. Never completely immerse the blade (C) in water.
Clean the housing with a damp cloth. Never immerse the housing in water nor rinse it with running water.
The cap (A) and the container (B) can be cleaned in a dishwasher, on the top shelf.
Make sure that they are located away from the heater. The maximum temperature is 50 °C.
10|EN
Useful tips
- For best results add the ingredients in the following
sequence: liquids, fresh vegetables and fruit, yoghurt.
- Cut any hard fruits and vegetables into small pieces
1.8-2.5 cm in length.
Do not use the device to:
- whip eggs,
- mash potatoes,
- mix hot liquids (above 50 °C),
- shred fruit with seeds or hard peel – it may damage
the blade,
- shred raw meat,
- shred only dry ingredients,