Steelcase Intermediate Worksurface Supports Manual De Instrucciones página 4

®
4.
Use the intermediate support as a
marking template by laying the large
plate on top of the lateral file and
aligning as shown.
FOR 18-3/8" TO 24" DEEP WORKSURFACES ONLY
1/2"
1/2"
INTERMEDIATE SUPPORT IS
PARALLEL TO THE LATERAL FILE.
THE MARKING TEMPLATE IS 1/2" FROM THE
SIDE AND BACK OF THE LATERAL FILE.
1/2"
INTERMEDIATE SUPPORT IS
PERPENDICULAR TO THE LATERAL FILE.
THE MARKING TEMPLATE IS 1/2" FROM THE
SIDE AND BACK OF THE LATERAL FILE.
FOR 23-1/2" TO 30" DEEP WORKSURFACES
INTERMEDIATE SUPPORT IS
PARALLEL TO THE LATERAL FILE.
THE MARKING TEMPLATE IS 7" FROM THE SIDE
AND 1/2" FROM THE BACK OF THE LATERAL FILE
FOR AN OFFSET POSITION INSTALLATION.
1/2"
INTERMEDIATE SUPPORT IS
PERPENDICULAR TO THE LATERAL FILE.
THE MARKING TEMPLATE IS 7" FROM THE BACK
AND 1/2" FROM THE SIDE OF THE LATERAL FILE
FOR AN OFFSET POSITION INSTALLATION.
7"
1/2"
7"
1/2"
Page 4 of 24
100141 Rev B