Steelcase Intermediate Worksurface Supports Manual De Instrucciones página 6

®
7.
Place the worksurface on top of the intermediate
support in it's final position with the back and the side
of the lateral file flush with the worksurface. Mark the
four (4) internal holes in the intermediate support as
shown.
8.
Remove the worksurface and the intermediate
support from the top of the lateral file. Turn the
worksurface upside down (8a) and carefully align the
intermediate support with the marked holes on the
bottom of the worksurface. Install four (4) 1" long
truss head screws provided (8b).
9.
With the help of another installer, flip the
worksurface assembly over and place over the
brackets (9a). Reinstall two (2) #10-32 x 1/2" flat
head screws provided (9b).
8a
7
7
9b
8b
6a
9a
Page 6 of 24
100141 Rev B