Krups XP 4000 Manual Del Usuario página 6

Appliance automatically cools down when
•
turning the selector to the O setting. When
cooling down the orange indicator light
comes on and hot water goes into drip tray.
When correct temperature is reached,
appliance is ready to run the espresso cycle.
Caution: during and after use of the
machine, the metallic parts of the
cappuccino accessory can become
extremely hot.
. Using the Cappuccino accessory
The Cappuccino accessory makes it easy to
produce frothy milk for making cappuccinos,
lattes and hot chocolates.
It is best to use fresh, skim or low-fat milk that
is well chilled (kept in the refrigerator). The
container must also be cold (do not run it
under hot water before frothing the milk).
For heating thick liquids, please refer to the
section "Heating thick liquids (e.g. soup)"
We recommend that you clean the
cappuccino accessory immediately after use -
please refer to section "Cleaning the
Machine".
Fill the water container with fresh, cold
•
water (1) (2) (3) and turn on the appliance
(4).
Move the cappuccino accessory to the
•
exterior of the appliance.
Turn the dial to the
•
Once the appliance reaches the right
temperature, the orange temperature control
light will go out.
Immerse the cappuccino accessory in the
•
milk to be heated (you can use a preferably
stainless steel container with a capacity of
about 0,5 litres).
Hold the container under the cappuccino
•
accessory in such a way that the tip is
immersed in the milk.
Turn the selector to the
•
Keep the container straight during this
operation. Do not allow the tip of the
cappuccino accessory to touch the bottom
of the container because this could obstruct
the steam output.
Once you have obtained the desired
•
quantity of frothy milk, turn the selector to
the setting (16) for the following
XP 4000 US/F/E PM6.5
setting (16).
setting (17).
13
cleaning operation in order to prevent the
milk from drying on the cappuccino
accessory.
remove the container.
•
place a container with water under the
•
cappuccino accessory.
select the setting again (17) to remove
•
the milk residue.
turn the selector to the O setting.
•
clean the cappuccino accessory with a damp
•
cloth.
For more thorough cleaning of the
cappuccino accessory, please refer to the
paragraph on maintenance.
. Heating liquids
Fill the water container (1) (2) (3) and turn
•
on the appliance (4).
Move the cappuccino accessory to the
•
exterior of the appliance.
Turn the selector to the setting
•
Once the appliance reaches the right
temperature, the orange temperature control
light will go out.
Immerse the cappuccino accessory in the
•
container holding the liquid to be heated.
• Then turn the selector to the
until the liquid is hot enough, then reset the
selector to the O setting and remove the
container.
For liquids other than water, turn the
•
selector to the setting
following cleaning operation in order to
prevent any blockage of the opening of the
cappuccino accessory :
place a container with water below the
•
cappuccino accessory.
select the setting again (17) to remove
•
the residue of the liquid.
turn the selector to the setting O.
•
clean the cappuccino accessory with a damp
•
cloth.
For more thorough cleaning of the
cappuccino accessory, please refer to the
paragraph on maintenance.
13/10/04, 11:03
(16) .
setting (17)
(16) for the
13