Remaining Hazards - Scheppach Basa 1.0 Traducción De La Instrucción De Original

priate working aids for bracing.
propriate saw blade to reduce the noise.
the work piece.
must be locked again.
the lower table plate half.
switching off.
the motor switched off and with the saw band at a stand-
still.
if only minor changes of place are envisaged. Properly
reconnect the machine to the supply mains before re-
commissioning.
the power supply plug.
X
Always disconnect the mains plug when the machine
is not used.
tional safety devices, functional switch. Do not use the
machine if the safety devices, the switch, the electrical
supply lines, the plug or other parts are damaged.
the lowest position and lock it before you transport the
machine. The door must always be closed and locked.
Use only as authorized
CE tested machines meet all valid EC machine guidelines as
well as all relevant guidelines for each machine.
machine before beginning work.
The operator is responsible for all other persons in the
working area.
the machine.
to the machine are always complete and perfectly leg-
ible.
designed exclusively for sawing wood, material similar to
wood, and non-ferrous metals and steel.
essed may not exceed with the standard design of the
table size.
Metal allows with more than 80 % magnesium may not
be processed due to the danger of fires.
saw can also be used to saw non-ferrous metal and plas-
tics. Material alloys containing more than 80% magne-
sium must not be processed due to the risk of fire. Use
only the saw blades offered by the manufacturer.
connected to a vacuum exhaust unit. Use the dust ex-
tractor to remove matchwood or saw dust. The vacuum
- sure 860 Pa.
on. This avoids overloading the circuit fuse.
thereby removed by vacuum exhaust, as required by
German regulations governing hazardous materials. This
results in savings in electricity consumption and reduces
noise levels, as the vacuum exhaust unit is on only dur-
ing machine tool operation.
lations must be used for suction in commercial areas.
tors while the work machine is in operation.
condition in accordance with its designated use and the
instructions set out in the operating manual, and only
by safety-conscious persons who are fully aware of the
risks involved in operating the machine. Any functional
disorders, especially those affecting the safety of the
- machine, should therefore be rectified immediately.
manufacturer as well as the technical data given in the
calibrations and dimensions must be adhered to.
erally recognized safety-technical rules must also be ad-
hered to.
ed by persons familiar with it and instructed in its opera-
tion and procedures. Arbitrary alterations to the machine
release the manufacturer from all responsibility for any
resulting damages.
and original tools made by the manufacturer.
is not responsible for any damages resulting from unau-
thorized use; risk is the sole responsibility of the opera-
tor.
ones specified in the operating instructions may present
a risk of injury for you.
The machine has been built using modern technology in ac-
cordance with recognized safety rules. Some remaining haz-
-
ards, however, may still exist.
band due to improper handling of the work piece.
improper handling, such as working without the push
stick.
chips. Wear personal protective cloth such as goggles.
Use a fitting dust extractor.
check saw band for such defects.
band. Wear proper gloves.
on the machine.
to injuries caused by electricity.

Remaining hazards

-
-
-
-
-
-