Electrical Connection - Scheppach Basa 1.0 Traducción De La Instrucción De Original

to be tensioned stronger than the small ones. Too high a
tension causes the untimely break of the saw band.
Side correction, figure 7
rection and perform the side correction via the handle
Caution!
nal head screw.
Fig. 7
Counter-pressure bearings, Fig. 8
pressure. Set the upper and lower counter-pressure bear-
ing such that it slightly touches the back of the sawblade.
Guide rollers, Fig. 8
sponding sawblade width. The front edges of the guide
rollers must not reach further than the tooth base of the
sawblade. When the guide rollers slightly touch the sawb-
lade, counter the roller seat with the knurled screw.
The sawblade must not jam!
Assembly of the mounting angle figure 9
washer A6 and a hexagonal nut M6. It is advisable to fas-
ten the machine on a workbench or a tabletop to exclude
the tipping-over of the bandsaw.
Suction connector
The suction connector is not positioned correctly for trans-
port reasons and must be turned until the fastening screws
are in a horizontal position.
An adapter is attached for industry vacuum cleaners; this
adapter is pressed into the suction connector.
Working information
The following recommendations are examples of the safe use
of band saws.
The following safe working methods should be seen as an
aid to safety. They cannot be applied suitably completely
or comprehensively to every use. They cannot treat every
possible dangerous condition and must be interpreted
carefully.
in closed rooms. A suction device which conforms with
commercial regulations must be used for suction in
commercial areas.
tension of the saw band to the machine for the next
user.
use faulty sawbands!
mounted on the machine before beginning work.
hand-held brush or scraper while the sawband is run-
14 english
must be cleaned regularly.
hearing protection. Wear a hairnet if you have long hair.
-
piece as possible when working.
machine.
-
piece from tipping or slipping away.
use the push stick.
ate position and guide the workpiece on the fence.
using both hands with the fingers together. Hold the
workpiece with your hands on a safe area.
round pieces.
-
safety when making traverse cuts.

Electrical Connection

The installed electric motor is connected and is ready to
work.
regulations.
The customer-side mains supply and the used extension
line must meet these regulations.
Installations, repair, and maintenance work relating to the
electric installation may only be performed by specialists.
Important Notes
The electric motor has been designed for the S 1 operating
mode.
In case of an overload of the motor, it turns off automati-
on the motor again.
Defective Electric Connection Lines
Often, insulation damages occur on electrical connection
lines.
door clearances.
nection line.
line out of the wall socket.
Such defective electric connection lines must not be used
- and are hazardous due to the insulation damages.
ages. Please make sure that the connection lines are dis-
connected from the mains supply during the check.
Electrical connection lines must comply with the relevant
with the type specification is required.
AC motor Fig. 10
-
-
-
-
-
-