Assembly; Fitting/Changing The Cutting Disc; Fitting/Setting The Rip Fence; Fitting The Water Inlet Hose - Parkside PDFS 1300 A1 Traducción Del Manual De Instrucciones Original

Assembly

Fitting/changing the cutting disc

WARNING! RISK OF INJURY!
■ Switch the appliance off and remove the
power plug before starting any work on the
appliance.
NOTE
■ Only use diamond cutting discs with diame-
ters corresponding to the inscriptions on the
appliance.
♦ Set the cutting depth (using the locking screw
) to the minimum position.
♦ Actuate the spindle lock
screw until the spindle lock
place. Loosen the clamping screw / washer
with the hex key
screw / washer and the clamping flange
(see also fold-out page, fig. A).
♦ Remove the cutting disc
♦ Fitting a cutting disc
reverse order.
♦ Actuate the spindle lock
screw until the spindle lock
place. Use the hex key
clamping screw .
WARNING!
► The arrow on the cutting disc
the direction of rotation arrow (running direc-
tion, marked on the appliance).
■ Make sure that the cutting disc
the speed of the tool.

Fitting/setting the rip fence

♦ Undo the wing screw
into the rip fence slot
PDFS 1300 A1
and turn the clamping
clicks into
. Now remove the clamping
.
is carried out in the
and turn the clamping
clicks into
to firmly tighten the
must match
is suitable for
and insert the rip fence
.
♦ Set the desired cutting width using the scale on
the rip fence and the rip fence slot
rip fence slot serves as an orientation mark
(see also fold-out page, fig. E).
♦ Retighten the wing screw

Fitting the water inlet hose

WARNING!
► Check the correct function of the residual
current circuit breaker
► Work with the appliance in a horizontal
position and not overhead to prevent water
from entering the machine.
► Before each use, check the water supply
system for leaks.
CAUTION!
► Do not connect the appliance to a water
supply system with more than 6 bar!
► Only use water as coolant.
♦ Set the cutting depth (using the locking screw
to the minimum position.
♦ Using a Phillips screwdriver and the accessory
screw supplied , fit the water inlet
housing (see also fold-out page, fig. B). Please
note that the water inlet
around the cutting depth adjustment. The two
water outlets of the water inlet
ed on the side of the cutting disc
fold-out page, fig. F).
♦ Push the water inlet hose
inlet .
♦ Insert the other end of the water inlet hose
into the water connection adapter
♦ Connect the water connection adapter
water hose with a suitable diameter of approx.
19 mm. Check for a tight fit by pulling on the
water hose.
♦ Open the valve
♦ Carefully adjust the amount of water at the water
source so that there is always enough water on
the cutting disc and the cutting area.
♦ Disconnect the water supply after completion
of the work.
. The
.
before each use!
to the
must be guided
must be locat-
(see also
into the water
.
on the water inlet .
GB │ MT │
57
)
to a
■