Reset Latch Signal At Output 1; Select Signal Form For Output Threshold 1 - Phoenix Contact MCR-FLP-D-T-2SP-24 Manual Del Usuario

Ocultar thumbs Ver también para MCR-FLP-D-T-2SP-24:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Set switching on hysteresis ∆a for alarm 1
Menu <–> Selection
Example 1.0
Select digit
Set digit
press the
key to accept the selection
Set switching off hysteresis ∆b for limit 1
Menu <–> Selection
Example: 1,0
Select digit
Set digit, then select signal form for output 1,
Chapter 5.5.1.6
press the
keey to accept the selection

5.5.1.5 Reset Latch signal at output 1

Menu <–> Selection
Manual reset with red key
Alarm output can only be reset manually if
is selected as the function and is displayed. If
lected as the function and is displayed, then the alarm output can only be
reset manually if the totalizer reset parameter
grammed as
Electrical reset with MPI-Input
Alarm output can only be reset electrically, if
is selected as the function and is displayed.
If
is selected as the function and is displayed, then the alarm out-
put can only be reset electrically if the totalizer reset parameter
has been programmed as
Note: The Display Hold funktion is off.
Both manual and electrical reset
Alarm output can either be reset manually via the red key or via a reset pulse
on the MP input. If
then the alarm output can only be reset manually and/or electrically if the to-
talizer reset parameter
press the
key
Note: The Display Hold function is off.
to accept
Page 22
23
or
,
is se-
has been pro-
or
.
or
,
.
is selected as the function and is displayed,
is programmed as
.
5.5.1.6 Select Signal Form for Output 1
Menu <–> Selection
press the
key
to accept
5.5.2 Alarm 2/Alarm output 2
5.5.2.1 Alarm2 on / off
Menu <–> Selection
5.5.2.2 Assign Alarm 2
Menu <–> Selection
a
5.5.2.3 Mode for Alarm output 2
Menu <–> Selection
press the
key to accept the selection
Positive output signal
Output is activated, when the instantaneous
value > alarm 1
Negative output signal
Output is deactivated, when the instantaneous
value > limit 1.
Example: on
Alarm 2 not activated,
Chapter 5.6,
Alarm 2 not activated, press the
key to accept the selection
Example: on
Totalizer
instantaneous value, press the
key to accept the selection
Example: on
Reset Latch mode, Latch signal at output 2
Chapter 5.5.2.5 ,
24
Auto mode
25
Page 23

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mcr-flp-d-t-2sp-230

Tabla de contenido