Operation - Phoenix Contact MCR-FLP-D-T-2SP-24 Manual Del Usuario

Ocultar thumbs Ver también para MCR-FLP-D-T-2SP-24:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5.10 Check/Alter Parameters
Menu <–> Selection
Checking the individual menu items
• after every 2 seconds the menu changes
to Selection
• If the setting is as desired, then switch to the next menu
with
key, otherwise, start the set-up again.
6

Operation

The unit is in the operating mode, when
the power supply is switched on or at the
end of the set-up.
326.81 The measuring signal has
been applied and lies within the
limits of the measuring range. The
display will show either the current
The input value is below the lower
limit of the measuring range. This
message alternates with the
˜ The input value is higher than the
upper limit of the measuring range.
This message alternates with the
The input value is less than -13.6 V.
Current inputs below 0.0 mA are not
measured.
The input value is higher than 11.0 V
or above 21.5 mA
Page 28
One of the following will be displayed dur-
ing operation.
measured value, the totalizer value,
the MAX value or the MIN value.
current measured value or with the
value of the totalizer.
current measured value or with the
value of the totalizer.
6.1 Changing the Display during Operation
Pressing the P key once for 2 sec will
identify the function currently selected. If
within these 2 sec the P key is pressed
again, then the display will proceed to
Pressing the
Key
Message
Display
1
Current measured value
1
MIN value (when activated)
1
MAX value (when activated)
2
Alarm 1 (when activated)
LED Pr1 ein
2
Alarm 2 (when activated)
LED Pr2 ein
1
Total
1 Following actuation the corresponding
value of the chosen function remains in
the display. During a PowerOff the func-
tion currently selected will be saved. At
the next PowerOn the corresponding
value of this function will be shown again
in the display.
Note:
When an alarm value is shown in the dis-
play, its set value can be changed.
the next display function. The new identi-
fication will be displayed for 2 sec to con-
firm this. After 2 sec the corresponding
value of the selected function will be dis-
played.
2 After 4 sec the display automatically
switches back to the current measured
value and the LED indicators Pr1 or Pr2
are turned off.
This can be prevented by disabling the
panel keys using the "Key" lock.
Page 29

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mcr-flp-d-t-2sp-230

Tabla de contenido