S&P HE 1800 Manual De Instalación página 9

3. INSTALLATION / WALL FITTING
3.1. Carefully read the Safety warnings before starting to install the appliance.
3.2. Make sure that your power supply corresponds to the details on the specifi cations plate:
230 V ~ 50Hz.
3.3. The appliance must be fi tted to the wall, respecting the minimum distances as shown in
Fig. 2.
3.4. Installing with the moveable support
• Loosen and remove the two side bolts as in Fig. 4. Remove the bracket from the ap-
pliance and secure the moving support with the 4 bolts supplied.
• Using the moving support (Fig. 1E) as a template, mark the 4 holes in the wall. Use a
spirit level to ensure the support is completely horizontal.
• Then drill the 4 holes in the wall using an 8 mm diameter drill. Insert the four bolts with
metal wall plugs and using the 4 nuts, secure the assembly to the wall. Use the span-
ner provided.
• Fit the appliance with the support and replace the side bolts. When the appliance is
facing in the desired direction, make sure it does not move.
3.5. IMPORTANT FOR FRANCE:
• Electrical power connection must be made by cutting off the supplied plug and using
an adequate terminal, as shown below.
Mains supply
• In damp areas or outdoor installations, the connection terminal should be installed at
least 25 cm above fl oor level. Make sure the cable does not touch the ground.
4. USE
4.1. You can switch the appliance on or off using the pull switch.
4.2. The remote control can be used to switch the lamps on or off at a distance.
4.3. The lamps can also be switched on or off using the small button under the control
box.
Model
HE 1800
HE 2400
Live= Brown
Earth= Yellow-Green
Neutral= Blue
Lamps Lamps power
1 1x1800W
2 2x1200W
9
Device cable
Total power
1800W
2400W