Oven Doors - GE JSS86 Manual Del Propietário

Oven Doors

Lift-Off Lower Oven Door
The door is very heavy. Be careful when removing and lifting the door.
Do not lift the door by the handle.
To remove the door:
1. Fully open the door.
2. Pull the hinge locks down toward the door frame, to
the unlocked position. A tool, such as a small flat-
blade screwdriver, may be required.
3. Firmly grasp both sides of the door at the top.
4. Close door to the door removal position. The door
should be open approximately 3" with no obstruction
above the door.
5. Lift door up and out until both hinge arms are clear of
the slots.
Slot
Hinge lock
Pull hinge locks down to unlock
Lift-Off Upper Oven Door (for double oven)
To remove the door:
1. Fully open the door.
2. Lift up on the hinge lock toward the oven frame until
they stop.
3. Close the door to 45 degrees (you will feel the door
stop). The hinge lock will contact the oven frame.
4. On both sides of the door, press down on the release
buttons on each hinge.
5. Lift door up until it is clear of the hinge.
6. Pull on hinge arms slightly to relieve pressure on the
locking tabs.
7. Push the hinge locks down onto the hinge.
8. Push the hinges in toward the unit so they are closed.
Oven
frame
22
To replace the door:
1. Firmly grasp both sides of the door at the top.
2. Starting on the left side, with the door at the same
3. Fully open the door. If the door will not fully open, the
4. Push the hinge locks up against the front frame of the
5. Close the oven door.
Hinge
Removal position
To replace the door:
1. Pull the hinges down away from the oven frame to
2. Lift up on the hinge locks toward the oven frame until
3. The hinges will release to the 45-degree position. The
4. Slide the door back onto the hinges. Make sure the
5. Fully open the door.
6. Push the hinge locks down onto the hinge.
7. Close the oven door.
Door
frame
Release
buttons
angle as the removal position, seat the indentation of
the hinge arm into the bottom edge of the hinge slot.
The notch in the hinge arm must be fully seated into
the bottom of the slot. Repeat for right side.
indentation is not seated correctly in the bottom edge
of the slot.
oven cavity, to the locked position.
Hinge
arm
lock
Push hinge locks up to lock
the fully open position.
they stop.
hinge locks will contact the oven frame.
buttons pop back out.
Push in
Hinge arm
Bottom
edge of
slot
Indentation
Pull down
49-2000993 Rev. 0