Taurus Adria 1400 Manual Del Usuario página 14

adequate temperature is selected.
Spray:
- The spray can be used in both steam and
dry ironing.
- Press the spray button to use this operation.
- The spray button has to be pressed
repeatedly to release the first spray.
Steam blast:
- This function proportions extra steam for
eliminating wrinkles.
- Press the steam blast button. Wait a few
seconds until vapour penetrates the fibres of
the garment before pushing the button again.
For optimum steam quality, do not apply more
than three successive blasts.
- The steam blast button has to be pressed
repeatedly to release the first shot.
Vertical steaming:
It is possible to iron hanging curtains, items
of clothing on his hanger, etc. To do so, follow
the instructions:
- Select the maximum temperature of the iron,
while turning the temperature regulator of the
iron in a clockwise direction.
- Move the iron in a top to bottom direction
while pressing the steam control. Important:
for cotton and linen, its recommended to put
the iron base in contact with the material. For
other more delicated fibres, it's recommended
to keep the iron base at some centimetres of
distance.
Once you have finished using the
appliance:
- Select the minimum position (MIN) using the
thermostat control.
- Remove the water from the water tank.
Cleaning
- Disconnect the appliance from the mains
and allow it to cool before undertaking any
cleaning task.
- Clean the electrical equipment and the
mains connection with a damp cloth and dry.
DO NOT IMMERSE IN WATER OR ANY
OTHER LIQUID.
- Do not use solvents, or products with an
acid or base pH such as bleach, or abrasive
products, for cleaning the appliance.
- Never submerge the appliance in water
or any other liquid or place it under running
water.
- If the appliance is not in good condition
of cleanliness, its surface may degrade
and inexorably affect the duration of the
appliance's useful life and could become
unsafe to use.
Self-cleaning function:
- It is important to self-clean the appliance at
least once a month to remove calcium and
any other built-up minerals inside the iron.
- Fill the depository to its maximum level, as
indicated on "water fill" section
- Place the iron in the vertical position, plug
into the mains and select the maximum
temperature.
- Leave the appliance to heat up until the
pilot light indicates that it has reached its
consigned temperature.
- Press the self-clean button, and keep it
pressed down.
- Let the water flow out through the steam