Maxon C2 Instrucciones página 9

NOTE: If Liftgate obstructs the original equipment lighting on the rear of the body, the
lighting should be moved or replaced with a rear lights kit that is compatible
with Liftgate.
1. Check for obstructions at rear of truck
frame and body (FIG. 9-1), that interfere
with:
• Installation of Liftgate.
• Interfere with visibility of rear lighting
• Obstruct access to spare tire
NOTE: Disconnect camera and sensor (if
equipped) harness from vehicle
before removing tailgate.
2. If equipped, remove tailgate and
mounting, and rear bumper and
mounting (FIG. 9-1).
3. If necessary, modify truck spare tire
crank, and/or access hole in the Lift-
gate that gives access to spare tire
winch.
LIFT CORPORATION Sht. 9 of 55 DSG#
PREPARING TRUCK
M-15-02
LIGHTING
BUMPER
TAILGATE
TRUCK WITH SERVICE BODY
Rev. E Date: 09/13/21
LIGHTING
FIG. 9-1