Publicidad
Idiomas disponibles
Idiomas disponibles
1.
/
: Increase / decrease setting; activate /
deactivate clock reception signal
2. RESET: Reset unit to default settings
3. AUTO ON / OFF: Select auto toggle mode
4. CLOCK: Set time and display mode
5. °C / °F: Select temperature unit and display mode
6. Battery compartment
REMOTE SENSOR
1. LED status indicator
2. Wall mount hole
3. Battery compartment
4. RESET hole
5. CHANNEL switch
GETTING STARTED
POWER SUPPLY
Batteries serve as back up power supply for the clock.
For continuous use of LCD backlight, always plug in
the adapter socket. Make sure the socket outlet is
easily accessible to the unit.
To insert batteries:
1. Remove the battery compartment and insert the
batteries, matching the polarities.
2. Press RESET after each battery change.
indicates main unit batteries are low.
REMOTE SENSOR
The main unit can be connected to only 1 remote
sensor.
To set up the outside sensor:
1. Open the battery compartment.
2. Select a channel then press RESET.
3. Close the battery door.
4. Place the outside sensor within 30 m (98 ft) of the
main unit using the table stand or wall mount.
TIP The transmission range may vary depending on
many factors. You may need to experiment with various
locations to get the best results.
3
Publicidad
Capítulos
