Sanus FMS01 Manual De Instrucciones página 18

8
Mount to Wall
Wood Stud
8-1
Locate studs
< 16 mm
(5⁄8 in.)
8-2
Mark the wall
8-3
Drill pilot holes
8-4
Tighten lag bolts
[06]
[39]
[38]
18
41cm
(16 in.)
[06]
Verify the center of the stud(s) using an awl, a thin nail, or an edge to
edge stud fi nder.
CAUTION:
Avoid potential personal injuries and property
damage!

Any material covering the wall must not exceed 16 mm (5/8 in.).

Minimum wood stud size: common 51 x 102 mm (2 x 4 in.)
(Nominal 38 x 89 mm {1½ x 3½ in.})
Level the wall plate [06] and mark the hole locations.
CAUTION:
Improper use could reduce the holding power of
the lag bolt. To avoid potential injuries or property damage: pilot
holes MUST be drilled to a depth of 75 mm (3 in.), using a 5.5 mm
(7/32 in.) diameter drill bit.
75 mm
3 in.
CAUTION:
Avoid potential injuries or property damage!
Improper use could reduce the holding power of the lag bolt. To
avoid potential injuries or property damage:

DO NOT over-tighten the lag bolts [38]

Tighten the lag bolts [38] only until the washers [39] are
pulled fi rmly against the wall plate [06]
13 mm 5.5mm
(1/2 in.) (7/32 in.)
6901-002145 <00>