Publicidad
GB - When the current-supply-cable is connected, the Led will flash red. A self-learning programme will automatically effect the synchro-
nization and selection of the related protocol. As soon as the synchronization has been completed, the Led will flash green and continue
flashing until the car-radio make is selected for programming.
CAR-RADIO SELECTION
To select the radio-model installed in the car, act on the steering-wheel commands:
press VOLUME+ to select the radio-model; press SEEK to memorize.
Clarion
Kenwood
Jvc
Alpine
Pioneer
Sony - Phonocar VM040-VM041
Panasonic
Blaupunkt
Phonocar VM020•VM021•VM022•VM023
Phonocar VM016
Phonocar VM030•VM031•VM032
Phonocar VM017
Should the selection not be correct, please check the number of blinkings indicated for the radio-model and, if necessary, rectify by
pressing VOLUME+ (to increase) or VOLUME- (to reduce).
When memorization has ben completed, the Led will turn green.
RE-SETTING OF DEVICE: Without interrupting the power-supply to the circuit, press the PRG-key until the green Led goes off.
The Led will flash red, for some seconds, and then turn green, until a different radio-model is selected.
PROGRAMMING PER RADIO-BRAND
do not press
press Vol+ 1 time.
press Vol.+ 2 times.
press Vol.+ 3 times.
press Vol.+ 5 times.
press Vol.+ 6 times.
press Vol.+ 8 times.
press Vol.+ 9 times.
press Vol.+ 12 times.
press Vol.+ 13 times.
press Vol.+ 14 times.
press Vol.+ 17 times.
Led green 1 blinking
Green Led blinks 2 times
Green Led blinks 3 times
Green Led blinks 4 times
Green Led blinks 6 times
Green Led blinks 7 times
Green Led blinks 9 times
Green Led blinks 10 times
Green Led blinks 13 times
Green Led blinks 14 times
Green Led blinks 15 times
Green Led blinks 18 times
GB
press SEEK+
press SEEK+
press SEEK+
press SEEK+
press SEEK+
press SEEK+
press SEEK+
press SEEK+
press SEEK+
press SEEK+
press SEEK+
press SEEK+
Publicidad
