Installation Steps; Care And Cleaning - WeatherTech Easy-On Stone & Bug Instrucciones De Instalación

Installation Steps

NOTE: Actual application may vary slightly from illustrations.
Rotate rubber seal back into position over Install (1) washer and screw and tighten until
hood shield flange and align with holes in hood snug. Repeat for remaining (3) fasteners.
shield.
hood
hood shield
rubber seal
washer
screw
3 4
DO NOT OVER TIGHTEN
Install bump ons at pre-cleaned locations on the hood surface where the hood shield
may contact.
5

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
A U T O M O T I V E
P R O D U C T S L I M I T E D
2435 WISCONSIN STREET
DOWNERS GROVE, IL 60515
PHONE (630) 769-1500 FAX (630) 769-0300
(800) 441-MATS (6287)
INTERNET ADDRESS: http://www.macneilauto.com
™
Page 2 of 2