Installation Steps - WeatherTech Easy-On Instrucciones De Instalación

Installation Steps

Note the location of the (4) square holes.
3
Align pre-drilled holes in hood shield with holes in hood. Place
hood shield on hood, ensuring protective fim is between the hood
shield flange and hood edge.
5
Note the location of the (2) remaining holes.
7
Close hood, and install bump ons at pre-cleaned loca-
tions on the painted hood surface.
9
NOTE: Actual application may vary slightly from illustrations.
Press (4) hood inserts into the (4) square holes. If
necessary use tape to hold them firmly in place.
4
Using a phillips screwdriver install (4) screws with (4)
washers at the locations noted in Step 3.
square hole
hood
hood insert
hood shield
washer
6
Insert (1) fastener and push firmly through hole in
hood shield and into hood to secure. Repeat for
8
Page 2 of 3
screw
DO NOT OVER TIGHTEN
remaining hole location.
DO NOT OVER TIGHTEN