Installation Steps - WeatherTech Easy-On Instrucciones De Instalación

Installation Steps

Remove the weatherstrip retainers at the locations indicated to
expose holes in hood.
NOT E : Use caution not to damage weatherstrip.
Press (4) hood inserts into the (4) exposed square holes.
If necessary use tape to hold them firmly in place.
Separate Fastener Assembly into two pieces.
Reinstall hood shield on hood. Carefully slide all flanges underneath weatherstrip.
NOTE: Actual application may vary slightly from illustrations.
Carefully lift the weatherstrip away from the hood surface at the
center (4) INBOARD locations indicated to expose square holes
in hood.
Carefully lift the weatherstrip away from the hood surface at the
(4) OUTBOARD locations indicated to expose holes in hood.
Press the female portion of the Fastener Assembly into
the (4) exposed holes. If necessary use tape to hold
them firmly in place.
Page 2 of 3